Das Musikding Forum
The Community for guitar and bass electronics DIY
This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.
Recent Activities
-
MAD -
Replied to the thread Madamp M15 with JJ E83CC in Phase Inverter position causes a very loud and uncontrolled hum.
PostHonestly - I'm confused by JJ's naming schema. It was already different in the past to other tube vendors, but is now even more confusing. In short, this is what was valid until some years ago: 1) Until the early 70s of the last century, there were… -
Hendrixianer -
Liked Poisoned’s post in the thread Led and resistor.
Like (Post)Thanks! -
Poisoned -
Replied to the thread Led and resistor.
PostThanks! -
carcalac -
Replied to the thread YouTube.com - Eure Lieblingsvideos?!?!.
Posts jibt schlechteres Playbacks jibt bessere Metallica-Songs
-
smellslikebleach -
Liked Hendrixianer’s post in the thread YouTube.com - Eure Lieblingsvideos?!?!.
Like (Post) -
Hendrixianer -
Replied to the thread The Face Germanium - Fuzz kit : cant reach bias voltage under 6.6V with trimpot.
PostI think by desolder R5 you did damage a Trace on the Solder side,if it is so,you can measure it,and repair it with a Wire. -
roh -
Liked Hendrixianer’s post in the thread The Face Germanium - Fuzz kit : cant reach bias voltage under 6.6V with trimpot.
Like (Post)Quote from roh: “(you mean measure if there is a connection, ” Yes,if all connections are good,and no shorts!,Wire connections too -
Hendrixianer -
Replied to the thread YouTube.com - Eure Lieblingsvideos?!?!.
Post -
Hendrixianer -
Replied to the thread Led and resistor.
PostTake a look in Net for Voltages and current for 3mm and 5mm LED´s,and compare,also there is a LED-Resistor Calculator you find with Google -
Hendrixianer -
Replied to the thread The Face Germanium - Fuzz kit : cant reach bias voltage under 6.6V with trimpot.
PostQuote from roh: “(you mean measure if there is a connection, ” Yes,if all connections are good,and no shorts!,Wire connections too